Profile
Custom / Default+
Torque
23 Nm
Family
Direct drive
Confidence
Medium
Wheelbases these settings are for
These settings are made for the models below. Open the sheet for full specs.
SIMAGIC Alpha U
23 Nm
Purchase links are affiliate links: if you buy through them, Gonky Racing earns a commission at no extra cost to you.
SIMAGIC Alpha U in Automobilista 2: Custom / Default+ profile, Gain 48, Low Force Boost 0, FX 24 and Damping 32.
In AMS2
Type
Custom / Default+
Gain
48
Low Force Boost
0
FX
24
Damping
32
Menu Spring Strength
100
On the device
SimPro Manager
Total Force
100%
Wheel Rotation Angle
900° / Auto
Smooth Level
Low
Mechanical Damper
Low
Mechanical Friction
Low
FFB Frequency
High
Model notes
- Stay at the low end of the Gain window: this motor is fast and strong.
- Mini can use a bit more Gain than Alpha U.
- If straights feel buzzy, calm the base before adding more in-game damping.
Every setting in SIMAGIC SimPro Manager
What each setting does, its range and what we set for AMS2. Anything without a value, leave at default.
Source: Official SIMAGIC blogThis brand does not publish a manual with the full settings list. Names come from their per-game guides and the community, so they may vary with the software version.
Force
Overall Strength / Maximum Torque
Default
Overall base strength. Equivalent to Fanatec's FF or MOZA's Game FFB intensity.
Model dependent: check the table above.
Wheel Return Speed
Default
Active centering assist.
Low or zero: AMS2 already simulates self-centring from caster.
Mechanical feel
Damping
Default
Resistance based on rotation speed.
Speed Dependent Damping
Default
Damping that scales with car speed. A Simagic speciality.
Mechanical Friction
Default
Adds weight to the shaft: the higher, the harder to turn.
Inertia
Default
Wheel weight. Careful: the more you raise it, the more road detail you lose.
Detail
Road Sensitivity
Default
How much road detail reaches your hands.
If the rim rattles on the straights, lower this before the Gain.
Filter
Default
Signal smoothing.
Soft Lock
Default
Software rotation limits.
About this base
23 Nm high-torque Direct Drive base with a custom 5-pole servo motor, 262144 ppr encoder and 200 MHz / 40 kHz electronics in an aluminium + carbon chassis.