Profile
Default+
Torque
3.9 Nm
Family
Belt
Confidence
Derived
Derived settings: there is no validated preset for this base, so we start from its family and torque recipe. An honest starting point, not dogma.
Fanatec ClubSport Wheel Base in Automobilista 2: Default+ profile, Gain 70, Low Force Boost 15, FX 35 and Damping 35.
In AMS2
Type
Default+
Gain
70
Low Force Boost
15
FX
35
Damping
35
Menu Spring Strength
100
On the device
Fanatec Tuning Menu
SEN
Auto
FF
100
DRI
Off / 1
SPR
0
DPR
0 - 20
Model notes
- This is the safe all-rounder for GT and touring cars.
- Raise Gain only if the FFB meter is not clipping.
Every setting in Fanatec Tuning Menu
What each setting does, its range and what we set for AMS2. Anything without a value, leave at default.
Source: Official Tuning Menu FAQMain
SEN — Sensitivity
For AMS2AUTO
Degrees of rotation. On AUTO the game sets it.
FF — Force Feedback
Default
Maximum motor strength when the game sends FFB.
Model dependent: check the table above.
FEI — Force Effect Intensity
For AMS280 – 100
Intensity and sharpness of effects: 0 is smoothest, 100 sharpest and most direct.
INT — FFB Interpolation
For AMS22 – 4
Smooths the game signal and raises its refresh rate. Higher = smoother.
LIN — FFB LinearityDD only
Default
Linearises the force response. DD bases only.
Natural effects (DD only)
Generated by the BASE, not the game. In AMS2 keep them low.
NDP — Natural DamperDD only
Default
Damping that reacts to wheel acceleration and angle.
Model dependent: check the table above.
NFR — Natural FrictionDD only
For AMS20 – 3
Simulates the mechanical feel of steering components.
NIN — Natural InertiaDD only
For AMS20 – 5
Simulates added weight on the steering axle. Useful with very light rims.
DirectInput effects
Effects the game requests via DirectInput. AMS2 does not use them heavily: leave at 100 unless you want them off.
FOR — Force
For AMS2100%
Scales constant force effects.
SPR — Spring
Default
Scales the spring effect (pulls the wheel to the dynamic centre).
AMS2 barely uses it; the default (100) is harmless.
DPR — Damper
Default
Scales the damper effect requested by the game.
Wheel / pedals
SHO — Shock
Default
Rim rumble motors, if your wheel has them.
BLI — Brake Level Indicator
Default
Vibrates when you reach the brake % you set.
BRF — Brake Force
Default
Brake pedal curve (load cell).
MPS — Multi Position Switch
Default
Mode for the rim multi-position switches.
About this base
The original ClubSport Wheel Base (V1/V2): belt-driven force feedback that launched Fanatec's modular ClubSport ecosystem of swappable wheels.
Wheelbases these settings are for
These settings are made for the models below. Open the sheet for full specs.
Fanatec ClubSport Wheel Base
Purchase links are affiliate links: if you buy through them, Gonky Racing earns a commission at no extra cost to you.