Profile
Custom / Default+
Torque
15 Nm
Family
Direct drive
Confidence
Medium
Wheelbases these settings are for
These settings are made for the models below. Open the sheet for full specs.
Fanatec ClubSport DD+
15 Nm
Purchase links are affiliate links: if you buy through them, Gonky Racing earns a commission at no extra cost to you.
Fanatec ClubSport DD+ in Automobilista 2: Custom / Default+ profile, Gain 42, Low Force Boost 0, FX 28 and Damping 34.
In AMS2
Type
Custom / Default+
Gain
42
Low Force Boost
0
FX
28
Damping
34
Menu Spring Strength
100
On the device
Fanatec Tuning Menu
SEN
Auto
FFB
100%
FFS
Peak
NDP
10 - 20%
NFR
0 - 3%
NIN
0 - 5%
INT
3 - 4
FEI
80 - 100
FOR
100%
Model notes
- Treat it closer to a high-torque DD than a CSL DD.
- If Default+ feels too busy, try Custom with the same Gain range.
Every setting in Fanatec Tuning Menu
What each setting does, its range and what we set for AMS2. Anything without a value, leave at default.
Source: Official Tuning Menu FAQMain
SEN — Sensitivity
For AMS2AUTO
Degrees of rotation. On AUTO the game sets it.
FF — Force Feedback
Default
Maximum motor strength when the game sends FFB.
Model dependent: check the table above.
FEI — Force Effect Intensity
For AMS280 – 100
Intensity and sharpness of effects: 0 is smoothest, 100 sharpest and most direct.
INT — FFB Interpolation
For AMS22 – 4
Smooths the game signal and raises its refresh rate. Higher = smoother.
LIN — FFB LinearityDD only
Default
Linearises the force response. DD bases only.
Natural effects (DD only)
Generated by the BASE, not the game. In AMS2 keep them low.
NDP — Natural DamperDD only
Default
Damping that reacts to wheel acceleration and angle.
Model dependent: check the table above.
NFR — Natural FrictionDD only
For AMS20 – 3
Simulates the mechanical feel of steering components.
NIN — Natural InertiaDD only
For AMS20 – 5
Simulates added weight on the steering axle. Useful with very light rims.
DirectInput effects
Effects the game requests via DirectInput. AMS2 does not use them heavily: leave at 100 unless you want them off.
FOR — Force
For AMS2100%
Scales constant force effects.
SPR — Spring
Default
Scales the spring effect (pulls the wheel to the dynamic centre).
AMS2 barely uses it; the default (100) is harmless.
DPR — Damper
Default
Scales the damper effect requested by the game.
Wheel / pedals
SHO — Shock
Default
Rim rumble motors, if your wheel has them.
BLI — Brake Level Indicator
Default
Vibrates when you reach the brake % you set.
BRF — Brake Force
Default
Brake pedal curve (load cell).
MPS — Multi Position Switch
Default
Mode for the rim multi-position switches.
About this base
15 Nm Direct Drive base (18 Nm holding torque after the May 2026 firmware), with a German-designed servo motor and QR2 Type-F. Strong torque headroom for formula and GT, on PC and PlayStation.